Jargon buster
Building safety jargon, explained
The abbreviations and technical words you'll see on certificates and quotes, in plain English.
- AFDD
- Arc Fault Detection Device. Switches off a circuit when it detects dangerous sparking in damaged cables.
- ANPR
- Automatic Number Plate Recognition. A camera that reads number plates to open a barrier for approved vehicles.
- AOV
- Automatic Opening Vent. A window or vent that opens by itself to let smoke out of a stair or corridor.
- ARC
- Alarm Receiving Centre. A 24/7 monitoring centre that receives signals from alarms and calls keyholders or police.
- BS 5266
- The British Standard for emergency lighting.
- BS 5839
- The British Standard for fire alarm systems. Part 1 covers non-domestic buildings, Part 6 covers homes.
- BS 7671
- The IET Wiring Regulations — the UK standard for electrical installations.
- C1 / C2 / C3 / FI
- EICR codes. C1 danger present, C2 potentially dangerous, C3 improvement recommended, FI further investigation needed.
- Call point
- The red 'break glass' box used to set off a fire alarm by hand.
- Category (L1–L5, M, P)
- How much of a building a fire alarm covers. L1 is full coverage, M is manual call points only, P is for protecting property.
- Commissioning
- Testing and setting up a new system to prove it works as designed, before handover.
- Compartmentation
- Dividing a building into fire-resisting sections so fire and smoke can't spread.
- Consumer unit
- The fuse board — where the electricity supply splits into circuits.
- CP12
- Informal name for the Landlord Gas Safety Record.
- Declaration of Conformity
- A document from the installer of a powered gate or barrier saying it meets the Machinery Regulations.
- DNO
- Distribution Network Operator — the company that owns the local power network (e.g. Electricity North West).
- Dry riser
- An empty pipe in a tall building that firefighters pump water into to reach upper floors.
- EACIE
- Evacuation Alert Control and Indicating Equipment — the fire service panel for an evacuation alert system.
- EIC
- Electrical Installation Certificate, issued for new circuits or rewires.
- EICR
- Electrical Installation Condition Report — a periodic health check of the wiring.
- F-gas
- Fluorinated greenhouse gases used as refrigerants in air con. Only certified engineers may handle them.
- FD30 / FD60
- A fire door rated to resist fire for 30 or 60 minutes. An 'S' (FD30S) means it also has smoke seals.
- Fire risk assessment
- A written review of fire hazards and precautions in a building. Required by law for workplaces and common parts.
- Fire stopping
- Sealing holes in fire walls and floors with tested products.
- Flick test
- The monthly short test of emergency lighting.
- Gas Safe
- The official register of engineers legally allowed to work on gas.
- Grade (A–F)
- How a home fire alarm system is built under BS 5839-6. Grade D1 is mains powered with a sealed backup battery.
- HMO
- House in Multiple Occupation — a property let to 3 or more people from 2 or more households sharing facilities.
- Induction loop
- A wire cut into the road that senses a vehicle above it, used with barriers and gates.
- Intumescent
- A material that swells up when heated to seal a gap — used in fire door strips and fire stopping.
- Maglock
- Magnetic lock. Holds a door shut with an electromagnet and releases when power is cut.
- MCB
- Miniature Circuit Breaker. Trips when a circuit is overloaded or short-circuited.
- NVR / DVR
- Network or Digital Video Recorder — the box that stores CCTV footage.
- O&M manual
- Operation and Maintenance manual handed over with a new system.
- Part P
- The part of the Building Regulations covering electrical safety in homes.
- PAT testing
- Portable Appliance Testing — checking plug-in equipment is safe.
- Photocell
- A safety beam across a gate or barrier that stops it closing on something.
- PIR
- Passive Infrared detector. Senses body heat moving — used in burglar alarms and lighting.
- PoE
- Power over Ethernet. One network cable carries both data and power to cameras or access points.
- RCBO
- A combined MCB and RCD protecting a single circuit.
- RCD
- Residual Current Device. Cuts power in a fraction of a second if current leaks to earth — for example through a person.
- Responsible person
- The person or organisation legally responsible for fire safety in a building.
- RRO / Fire Safety Order
- The Regulatory Reform (Fire Safety) Order 2005 — the main fire safety law for non-domestic premises and common parts in England and Wales.
- Smoke seal
- A brush or rubber strip around a fire door that stops cold smoke passing.
- SPD
- Surge Protection Device. Protects equipment against voltage spikes.
- Stay put
- A fire strategy for flats where residents not affected by the fire stay inside their own flat unless told to leave.
- TM44
- An energy inspection required every 5 years for air con systems over 12 kW.
- UKCA / CE mark
- Markings showing a product (or a powered gate as installed) meets UK or EU safety rules.
- URN
- Unique Reference Number issued by the police for alarm systems that qualify for police response.
- VAD
- Visual Alarm Device — a flashing beacon on a fire alarm.
- Zone plan
- A drawing by the fire panel showing which area each alarm zone covers.
This guide is a plain-English summary to help you understand your duties. It is not legal advice, and rules can change. Your fire risk assessment, insurer or local council may ask for more.
Manufacturers we work with
We install, service and repair equipment from all of these manufacturers. The most relevant for this page are shown first.
Need a certificate, a repair or a quote?
Tell us the address and what you need. We reply the same working day.