Fault guide · Barriers
Barrier loop detector faults explained
Induction loops cut into the road tell the barrier when a vehicle is there. When they go wrong, barriers open on their own, stay up, or close too early.

Updated 5 November 2026
Quick answer
A loop detector measures a change in the magnetic field of a cable loop cut into the road. Damaged loop cable, poor sealing, nearby steel, interference between loops or the wrong sensitivity setting cause most faults.
How loops are used
- Presence or safety loop: stops the arm closing on a vehicle under it
- Exit loop: opens the barrier automatically for vehicles leaving
- Closing loop: closes the barrier once the vehicle has passed
Symptoms and causes
| Symptom | Likely cause |
|---|---|
| Barrier opens with no vehicle | Sensitivity too high, crosstalk with another loop |
| Barrier stays up | Loop detector stuck in detect, damaged cable |
| Barrier closes too early | Sensitivity too low, loop too small for high vehicles |
| Intermittent faults after rain or frost | Water in a cracked loop slot or joint |
The fix
We test the loop's resistance and insulation, check the detector's frequency and sensitivity, and re-cut and seal a new loop where the old one is damaged. New loops can usually be cut and sealed in a single visit.
Related services
Related guides
Questions we get asked
Can loops be repaired or must they be replaced?
A damaged loop in the road is usually replaced with a new cut. Faults in the feeder cable or detector can often be repaired.
Do road works affect loops?
Yes. Resurfacing or planing often cuts loops, so tell the contractor where they are.
Need this done?
Tell us the address and what you need, or send a photo. We reply quickly with a clear written quote, covering anywhere in the UK.
Manufacturers we work with
We install, service and repair equipment from all of these manufacturers. The most relevant for this page are shown first.
Need a certificate, a repair or a quote?
Tell us the address and what you need. We reply the same working day.