Fire, electrical & security compliance07517 806082
Get a quote

Electrical, gas & energy

Air conditioning explained

Indoor units, outdoor units, refrigerant rules and when you need leak checks.

Who's responsibleThe 'operator' — usually the building owner or tenant who controls the system
Most frequent checkYearly
Parts explained7 components

In plain English

A split air conditioning system has an indoor unit that blows cool (or warm) air and an outdoor unit that moves heat outside. Refrigerant gas flows between them through insulated copper pipes.

Why it matters: Refrigerants are powerful greenhouse gases, so only certified engineers can handle them, and bigger systems must be leak checked by law.

What the law says

  • UK F-gas Regulations

    Only F-gas certified engineers working for a certified company can install or service systems containing refrigerant. Systems holding refrigerant equal to 5 tonnes of CO2 or more must be leak checked at least yearly (more often for bigger systems).

  • Energy Performance of Buildings Regulations

    Air con systems with a combined output over 12 kW need an energy inspection (TM44 report) at least every 5 years.

Standards we work to

  • BS EN 378 — Safety and environmental requirements for refrigerating systems and heat pumps.

Who is responsible?

The 'operator' — usually the building owner or tenant who controls the system.

The components we install

These are the parts that make up a typical air conditioning installation, what each one does, and what a healthy one looks like.

  • Indoor unit

    Wall-mounted, ceiling cassette or ducted. Blows conditioned air into the room.

    What to look for: Clean filters, no drips.

  • Outdoor unit

    Holds the compressor and fan. Rejects heat outside.

    What to look for: Clear airflow, no debris.

  • Refrigerant pipework

    Two insulated copper pipes between the units.

    What to look for: Insulation intact, not crushed.

  • Condensate drain / pump

    Carries away water the unit takes out of the air.

    What to look for: No leaks or overflow.

  • Controller / remote

    Sets temperature, mode and timer.

    What to look for: Works, batteries good.

  • Isolator

    Lets engineers safely cut power at the outdoor unit.

    What to look for: Weatherproof.

  • Filters

    Catch dust before it gets into the coil.

    What to look for: Clean them every few weeks in heavy use.

How often it must be checked

  • YearlyService: filters, coils, drains, refrigerant and electrics checked.By: F-gas certified engineer
  • Yearly or moreLeak check if the system is 5 tonnes CO2 equivalent or more.By: F-gas certified engineer
  • Every 5 yearsTM44 inspection for systems over 12 kW.By: Accredited energy assessor

See the testing schedule for every system →

Paperwork you should get

  • F-gas records — Refrigerant type, amount, leak checks and repairs.
  • Commissioning sheet — Pressure test and settings on install.
  • TM44 report — Where required.

Certificates explained →

Simple checks you can do

  • Clean or vacuum filters regularly.
  • Keep the outdoor unit clear of leaves and bins.
  • Report water leaks or ice on pipes.

Common questions

Does my small home system need a leak check?

Usually not. A typical single split unit holds less than 5 tonnes CO2 equivalent. We'll tell you on install.

Need this installed, tested or certified?

We install, service and certify this equipment and hand you every certificate in plain English.

Related guides

This guide is a plain-English summary to help you understand your duties. It is not legal advice, and rules can change. Your fire risk assessment, insurer or local council may ask for more.

Need a certificate, a repair or a quote?

Tell us the address and what you need. We reply the same working day.