Electrical, gas & energy
EV chargers explained
What goes into a safe home or workplace car charger, and the rules installers follow.
In plain English
An EV charge point is a wall-mounted unit on its own dedicated circuit that safely charges an electric car. It talks to the car, controls the current and, by law, must be 'smart'.
What the law says
Electric Vehicles (Smart Charge Points) Regulations 2021
New home and workplace charge points must be smart (able to change when they charge), set to charge off-peak by default, and meet security requirements.
Building Regulations — Part S
Most new homes and new or major renovated non-residential buildings with parking must have EV charge points.
Building Regulations — Part P
A charger is a new circuit, so it's notifiable building work in a home.
Standards we work to
- BS 7671 Section 722 — Special wiring rules for EV charging.
- IET Code of Practice for EV Charging Equipment Installation — Industry guidance installers follow.
Who is responsible?
The installer is responsible for a safe install and telling the electricity network operator (DNO). The owner is responsible for keeping it maintained.
The components we install
These are the parts that make up a typical ev chargers installation, what each one does, and what a healthy one looks like.
Charge point unit
The wall box that controls charging, usually 7 kW at home.
What to look for: Case undamaged, status light normal.
Tethered cable or Type 2 socket
Either a fixed cable or a socket you plug your own cable into.
What to look for: No cuts or crushed sections.
RCD protection
Special type that also detects DC leakage from the car.
What to look for: Built into the unit or the board.
Open-PEN protection / earth rod
Protects against a rare but dangerous supply fault. Usually built into modern chargers.
What to look for: Fitted as the installer specified.
Dedicated circuit
Its own cable and breaker from the consumer unit.
What to look for: Labelled at the board.
Isolator
Lets you switch the charger off locally.
What to look for: Accessible.
Load management (CT clamp)
Senses how much power the house is using and slows charging so the main fuse isn't overloaded.
What to look for: Clamp on the meter tails.
How often it must be checked
- YearlyVisual check and functional test (recommended).By: Qualified electrician
- With your EICRIncluded in the periodic inspection.By: Qualified electrician
Paperwork you should get
- EIC — Electrical Installation Certificate for the new circuit.
- DNO notification — The network operator is told about the new load.
- Part P certificate — Building regs compliance for homes.
Simple checks you can do
- Coil the cable neatly; don't drive over it.
- Check the unit after storms or impacts.
- Keep the app updated.
Common questions
Do I need a new main fuse?
Not usually. Load management lets most homes add a charger without upgrading. We check this on survey.
Need this installed, tested or certified?
We install, service and certify this equipment and hand you every certificate in plain English.
Related guides
This guide is a plain-English summary to help you understand your duties. It is not legal advice, and rules can change. Your fire risk assessment, insurer or local council may ask for more.
Manufacturers we work with
We install, service and repair equipment from all of these manufacturers. The most relevant for this page are shown first.
Need a certificate, a repair or a quote?
Tell us the address and what you need. We reply the same working day.