Fire, electrical & security compliance07517 806082
Get a quote

Fire safety

Fire stopping and compartmentation explained

Sealing the holes in walls and floors so fire can't sneak through.

Who's responsibleThe building owner or responsible person
Most frequent checkAfter any work
Parts explained7 components

In plain English

Buildings are split into fire-resisting 'compartments' — walls and floors that hold back fire for 30, 60 minutes or more. Every time a pipe, cable or duct goes through one, the hole must be sealed with tested fire-stopping products.

Why it matters: A single unsealed cable hole can let smoke and fire into the next flat or the escape stairs, defeating the whole fire strategy.

What the law says

  • Building Regulations — Approved Document B

    Compartment walls and floors must keep their fire resistance, including where services pass through.

  • Regulatory Reform (Fire Safety) Order 2005

    Compartmentation is a key part of the fire precautions that must be maintained.

  • Building Safety Act 2022

    In higher-risk buildings, compartmentation records are part of the 'golden thread' of building information.

Standards we work to

  • BS EN 1366-3 — Fire test for penetration seals.
  • ASFP guidance — Industry best practice for fire stopping installation.

Who is responsible?

The building owner or responsible person. Any trade that drills a hole must reseal it properly.

The components we install

These are the parts that make up a typical fire stopping and compartmentation installation, what each one does, and what a healthy one looks like.

  • Fire batt

    A coated mineral wool board used to seal larger openings with lots of cables.

    What to look for: Coating intact, no gaps at edges.

  • Intumescent sealant

    A mastic that swells in heat. Used round pipes and small gaps.

    What to look for: Fully filled, not foam.

  • Pipe collar / wrap

    Fitted round plastic pipes. In a fire it crushes the melting pipe shut.

    What to look for: Fixed tight to the wall or ceiling.

  • Fire pillow

    Bags of intumescent material for openings that change often.

    What to look for: Packed tight.

  • Fire damper

    A shutter inside ductwork that closes in a fire.

    What to look for: Tested and accessible.

  • Cavity barrier

    Stops fire spreading inside hidden voids in walls and roofs.

    What to look for: Continuous, not cut away.

  • Identification label

    Tag showing who sealed it, with what, and when.

    What to look for: Present and readable.

How often it must be checked

  • After any workCheck that new holes have been sealed with the right product.By: Contractor / site manager
  • Yearly (typical)Compartmentation survey in blocks and HMOs, as the fire risk assessment requires.By: Competent surveyor

See the testing schedule for every system →

Paperwork you should get

  • Fire stopping register — Photo record of every seal, product used and location.
  • Compartmentation survey report — Lists gaps found and repairs needed.

Certificates explained →

Simple checks you can do

  • Look above ceilings and in risers for open holes.
  • Never use ordinary expanding foam as fire stopping.
  • Ask every contractor how they'll reseal holes.

Common questions

Is pink 'fire foam' OK?

Only some foams are tested, and only for certain gaps. Most open holes need a tested system fitted by someone trained to install it.

Need this installed, tested or certified?

We install, service and certify this equipment and hand you every certificate in plain English.

Related guides

This guide is a plain-English summary to help you understand your duties. It is not legal advice, and rules can change. Your fire risk assessment, insurer or local council may ask for more.

Need a certificate, a repair or a quote?

Tell us the address and what you need. We reply the same working day.